MCZ PowerTherm - Manual (Page 31)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 31
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4.4. LCD REMOTE CONTROL
4.4.1. General characteristics of the LCD remote control
The stoves are mainly controlled by the remote control or, in case of
emergency, from the small rear panel.
The radio frequency LCD remote control lets you take full advantage of
all the features of the stove, adjust all of the operating parameters, set
the timer, but most of all continuously monitor the room temperature
so as to suitable control the stove's operation.
In fact, the temperature sensor is built right into the remote control.
This allows more precise measurement of the temperature in the room
to be heated wherever the user wants, and without the inconvenience
and limitations of wired thermostats.
The remote control has bright back-lighting which is activated by simply
pressing a key.
Keep the remote control away from direct heat and
water.
It is advisable to keep it out of the reach of children.
The remote control should always be kept near the
stove (within a radius of 5 m) so that correct room
temperature values are transmitted. If the stove does
not receive any input from the remote control for at
least three hours, it will start emitting periodic
acoustic signals to inform the user that the remote
control is too far away or that the batteries are dead.
The display of the emergency panel will show the
alarm A10. In this alarm condition, the stove will
continue working. To eliminate the alarm, just move
the remote control nearer to restore normal operating
conditions.
4.4.2. LCD Remote control
1
2
3
4
5
6
7
KEY
1. Position of the room temperature probe
2. Back-lit LCD
3. On/off button. By pressing this button in combination with
others, you can access other menus such as the one for setting
the current time.
4. Button to select operating mode (MANUAL – AUTOMATIC –
AUTOMATIC WITH ECO-STOP). By pressing this button in
combination with others it is possible to access other menus
such as the menu to set the current time or to customise the
timer P99.
5. Button for scrolling up or down to adjust ventilation and flame
power, and any other adjustment.
6. The MENU button lets you access setting menus for ventilation,
SLEEP mode and TIMER
7. Support base that contains the battery compartment
Position of the room temperature probe