MCZ PowerTherm - Manual (Page 40)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 40
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
4.8.4.1. Activation /de-activation of ECO-STOP mode
This mode makes it possible to optimize stove consumption in well-
insulated rooms.
This operation can be selected whether your are in manual or
automatic mode by pressing and holding button 4 for 5 seconds.
The display of the remote control will show the message AUTO along
with the message ECOSTOP.
To disable the ECO-STOP function follow the same procedure.
4.9. HOT AIR VENTILATION
In this version the unit is equipped with two ventilators which guide the
hot air frontally. For convenience we will call “ventilator1” the one
which expels the air on the front right and “ventilator 2” the one with
front left outlet.
The adjustment of the two fans summarised in the table below is
independent and is set using the remote control.
Type Fan speed
Fan 1 0 1 2 3 4 5
Fan 2 0 1 2 3 4 5
35 POSSIBLE COMBINATIONS
THE COMBINATION 0-0 IS NOT ADMITTED
Activate the ventilation icon using the key (6) of the remote control.
Number 1 will appear above the bars symbol (17) indicating the
ventilation speed. This indicates that the “fan 1” is being programmed.
Adjust the intensity using the button (5). Press the key (6). Number 2
will appear above the bars, indicating that the “fan 2” is being
programmed. Adjust the intensity using the button (5).
Example with ventilation set to AUTO:
If the flame is at power 3, the fan will automatically set to power 3. If
the flame is at power 1, the fan will automatically set to power 1, and
so on.
If the keypad is not touched for 7 seconds, the
remote control will automatically exit fan setting
mode and will confirm the last inserted setting.
If a low ventilation is set, the stove power is self-
limited to avoid the overheating of the structure and
of the air coming out of the room fans.
A
B
6
5