MCZ PowerTherm - Manual (Page 14)

Chapter 3
INSTALLATION AND USE MANUAL
page 14
Installation and fitting Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
3. INSTALLATION AND ASSEMBLY
3.1. DRAWINGS AND TECHNICAL CHARACTERISTICS
POWERTHERM TECHNICAL CHARACTERISTICS
Overall thermal power
Max. 10.5 kw / 9.030
kcal/h
Overall thermal power
Min.
2.6 kw / 2.236 kcal/h
Yield at maximum 91.7 % (> 90%)
Yield at minimum 92.6 % (> 90%)
Temperature of exhaust
smoke at maximum
180°C
Temperature of exhaust
smoke at minimum
70°C
CO at 13%O
²
at Min and
at Max
0.042 — 0.019%
CO
2
at minimum and
maximum
4.3% – 8.5%
Mass of smoke at
minimum and maximum
4.0 – 8.3 g/sec
Minimum draught at
maximum power
0,10 mbar – 10 Pa
Minimum draught at
minimum power
0,05 mbar – 5 Pa
Hopper capacity 26 litri
Fuel pellet type
Pellet Ø 6-8 mm.
Pezzatura 5/30 mm
Pellet consumption per
hour Min ~ 0,6 kg/h *
Max.~ 2,2 kg/h *
Operating time between
re-fuelling Al min ~ 28 h *
Al max. ~ 8 h *
Heatable volume m 3 226/40 – 258/35 –
301/30 **
Combustion air inlet Ø 50 mm.
Smoke outlet Ø 80 mm.
Maximum absorbed
electrical power Max 420 Watt
Med 100 Watt
Power supply frequency
and voltage
220 Volt / 50 Hz
Net weight 170 Kg.
Weight with packaging 190 Kg.
Note
* Data that may vary depending on the type of pellets used.
**Heatable volume based on demand of cal/m 3 40-35-30 (respectively 40-35-30 Kcal/h for m 3 )
Appliance suitable for installation in a shared flue.