MCZ PowerTherm User Manual
Page 28
Chapter 3
INSTALLATION AND USE MANUAL
page
28
Installation and fitting
Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
For the sake of simplicity, in chapter 3.18 there is a mask for drilling all
holes with relative sizes.
3.17. OPENING/CLOSING PELLET DOOR
The door is closed by pressing. Therefore it does not have any handles
or grips.
To open or close the door, press on the upper left corner. This simple
pressure will attach or detach the door from the closing device on the
door frame.
3.18. DIAGRAM FOR MAKING HOLES ON CLADDING
The diagram hereunder is relative to the three positions of the legs Kit
mentioned in section 3.4.
When installed on a masonry base as foreseen by section 3.3, measure
the distance between the floor and lower edge of the counter frame.
This measurement is our value “K”. Compare the measured "K" with
those shown in the table and choose the one nearest to that
measurement. To obtain new measurements “C, D, E” , it is sufficient
to add the difference between the measured "k” and that in table (ß),
to measurements in the respective line.
E.G.: measured K= 630mm (the K nearest to our value is 600 mm) -> ß= 630-600= 30mm
C= 1377+ ß= 1407 mm ; D= 1162+ ß= 1192 mm ; E= 617+ ß= 647 mm
250
250
386
386
386
220
220
220
B
B
C
60
0
E
K
167
A
219
730
A
DX
SX
K (mm)
B (mm)
C (mm)
E (mm)
500 Ax0,27+1194
1400 520
600 Ax0,27+1294
1500 620
700 Ax0,27+1394
1600 720
Opening/closing pellet door