MCZ PowerTherm - Manual (Page 23)

Chapter 3
INSTALLATION AND USE MANUAL
page 23
Installation and fitting Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
IMPORTANT!
The cable for the connection of the light/fan is made
of silicone material to withstand high temperatures. If
you use extension cords (over 2.5 m) or in any other
circumstance, make sure that the cord does not come
into contact with the hot parts of the stove and of the
air connection hoses in the cladding of the structure.
If you install the air kit with illumination, it is
necessary to pre-install the light on the kit before
inserting it in the hole.
The light switch is not included in the supply.
Maintenance of air outlet with illumination
ATTENZIONE!
DISCONNECT THE 230V POWER CORD BEFORE
PERFORMING ANY MAINTENANCE.
x
Light bulb replacement
1. remove the air outlet by pressing on its sides
2. unscrew the light bulb that has burned out
3. screw in the new light bulb (15 Watt).
4. re-insert the air outlet
Use only light bulbs that are resistant to high
temperatures, such as those used in kitchen ovens.
x
Cleaning glass light fixture of the air outlet
1. Open the door that contains the dehumidification container.
2. Remove the container
3. With the key provided, loosen the two screws, so that the
bracket that supports the glass slides in the slots. Hold the
glass with one and with the other free it from the bracket.
Remove it and clean it.
4. Once you have cleaned the glass, re-insert it in its seat. Secure
it by following the previous steps in reverse order.
5. Put the container and door back in place.
IMPORTANT!
When you unscrew the screws to remove the glass,
hold the glass with one hand; otherwise it will fall.
Figure 6-Lamp electrical connections
1
2
Figure 7– Position of ventilator
terminals