MCZ PowerTherm - Manual (Page 15)

Chapter 3
INSTALLATION AND USE MANUAL
page 15
Installation and fitting Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
3.2. PREPARATION AND UNPACK ING
The unit is delivered in a single package.
Open the packaging (1), remove the tie (2), remove the protective
polystyrene and the box (3) located above the unit. The pipe and the
loading flap are packed in the box together with the components for
forced ventilation. Lastly, remove the unit from the pallet by
unscrewing the two screws which lock it in place and place it in the
chosen location making sure that this conforms to that foreseen.
The stove body or unit must always be kept in a vertical position when
moved, and moved only using carts. Special care must be used to
protect the door and the glass from impacts that would damage them.
Moving the product must always be done with care. If possible, unpack
the stove in the area where it is going to be installed.
The materials which make up the packaging are not toxic or harmful,
so no special procedures for disposal by required.
Their storage, disposal or possible recycling are therefore the responsibility
of the final user, in compliance with current legislation on the subject.
Do not store the stove unit or its cladding without their packaging.
If the stove needs to be connected to a discharge pipe which goes
through the rear wall (to connect up with the flue), take the greatest
care to make sure that the joint is not stressed.
Use the four adjustable feet (J) to get the stove correctly levelled so
that the smoke outlet (S) is lined up with the connecting pipe (H) .
3.3. ASSEMBLING THE UNIT ONTO THE MASONRY
BASE
Place the unit onto the masonry base and verify that the unit is
perfectly level to ensure that it works properly.
You must anchor the unit to the base so that, during annual
maintenance by an authorized technician, the combustion chamber may
be removed from its housing by means of the two extensible guides.
In this situation, the centre of balance of the unit moves forward
significantly. If the product has not been anchored to the base, it may
lose stability.
To attach the unit to the base, use expansion plugs and 6 o 8 mm
("Fischer” type or similar)
Fixing the unit to the base is obligatory.
Build the base so that the "fischer" plugs have
sufficient grip.
MCZ shall not be held liable for damage to persons or
things if this warning is ignored.
1
3 2
Powertherm Pack
>30mm
90°
90°
Position the holes for fixing the unit at
the base of both sides
Flat washer
Screws
Brass plug