MCZ PowerTherm - Manual (Page 33)

PELLET STOVES Chapter 4
INSTALLATION AND USE MANUAL page 33
Operation Technical service - Rights reserved MCZ S.p.A. - Reproduction prohibited
PLEASE NOTE:
Icons 11, 12, 13, and 14 may be on in two different ways:
x COMPLETELY LIT (ICON COMPLETELY BLACK)
x ONLY BORDER OF ICON LIT
When the icons are completely lit it means that work is being
carried out in this function.
Example: if the symbol of the fan is completely on, it means you
are changing the hot air fan speed via button no.5.
If only the borders of the icons are lit it means that the function is
active but cannot be modified except by entering the corresponding
item from the menu. When you enter the corresponding menu, the icon
comes on completely (see above)
Example: if only the border of the icon for the fan is on, it will not
be possible to modify the fan speed by pressing button no.5 but the
function is active because the fan is operating (if the stove is on). In
order to change the fan speed, simply access the menu that allows this
adjustment and causes the icon to light up completely.
4.4.4. Type of batteries and replacement
The batteries are housed in the lower part of the device at the support
base.
Operation requires 3 AAA batteries 1.5 V.
Via icon no. 4, the remote control informs the user when the batteries
are nearly dead. If the icon showing an empty battery appears, it
means that the batteries are nearly dead and that the remote control is
about to shut off.
If the remote control shuts off due to dead batteries,
the stove can only be controlled from the rear
emergency panel (see paragraph 4.5). Only a few
essential functions remain active during emergency
operation: power on, power off and manual
adjustment of three levels of power/ventilation.
The batteries provided may have a limited lifespan.
When replacing the batteries, ensure correct polarity
by observing the symbols on the internal
compartment of the remote control.
Dead battery indicator