MCZ Philo - Manual (Page 37)

PELLET STOVES Chapter 7
USE AND MAINTENANCE MANUAL page
37
Safety devices and alarms Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
WORDING
DISPLAYED
TYPE OF FAULT SOLUTION
A09
The smoke sensor is faulty and does not
correctly detect the temperature of the
exhaust smoke
Contact an authorised service centre to have the
component replaced.
A10
The pellet igniter is faulty
Contact an authorised service centre to have the
component replaced.
A11
Pellet supply fault
Contact an authorised service centre to have the
component replaced.
A12
The remote control has been out of reception
range of the stove for more than three hours
(or has flat batteries).
NOTE: in this case ONLY the stove will not
switch off in the alarm mode but will continue
to operate in the mode that the remote
control had set when the last command was
given. Bring the remote control back into the reception range
of the stove (or replace the batteries in the remote
control if they are flat). As soon as the stove picks up a
new signal from the remote control the warnings
shown on the alarm will disappear. You can force a
transmission to the stove easily by pressing button 4
(which changes the operating mode from manual to
automatic and viceversa)
A13
Generic fault in the electronic control unit
Contact an authorised service centre to have the
component replaced.
A14
Fault in the air flow sensor
This alarm does not lock the system. It only appears
on the warning screen. Contact an authorised service
centre to have the component replaced.
SEr
Regular maintenance advice
When the stove is switched on and this message
flashes this means that the preset operating time
before maintenance has expired and maintenance is
due to be carried out. Contact a qualified MCZ
technician.