Connecting the hot air duct – MCZ Philo User Manual
Page 21
PELLET STOVES
Chapter 3
USE AND MAINTENANCE MANUAL
page
21
Installation and assembly
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
3.4. CONNECTING THE HOT AIR DUCT
Once the stove has been positioned correctly, you may start installing the
hot air piping.
The air can be channelled by fastening two hoses to the back of the stove to
correspond with the holes at the top of the stove. To connect the pipe,
remove the top, thread the pipe and fasten it with a clamp.
The direction of the air exiting the stove can then be changed at any time,
even if ducting has been carried out.
There are two handles on the top of the stove that allow you to
discharge the hot air in the direction of your choice:
POSITION 1: AIR ON LEFT SIDE
POSITION 2: AIR ON RIGHT SIDE
POSITION 3: AIR AT THE FRONT
POSITION 4: AIR DUCTED
POSITION 5: handle A - AIR DIFFUSED
POSITION 6: handle B - AIR DIFFUSED
The ducting can also be walled. (SEE OPTIONALS)
POS.1
POS.2
POS.3
POS.4
POS.5
POS.6
A
B