Caution, Safety devices and alarms – MCZ Philo User Manual
Page 35

PELLET STOVES
Chapter 7
USE AND MAINTENANCE MANUAL
page
35
Safety devices and alarms
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
7. SAFETY DEVICES AND ALARMS
7.1. SAFETY DEVICES
The stove is fitted with the following safety devices:
SMOKE TEMPERATURE SENSOR
This sensor detects the temperature of the smoke, permitting the
stove to start up or shut down when the temperature of the smoke
drops below the preset value.
PELLET TANK TEMPERATURE SENSOR
If the temperature exceeds the safety value set the stove
immediately stops operating. To restart the stove, the sensor must
be reset manually. This can only be done once the stove has
cooled down.
ELECTRICAL SAFETY
The stove is protected against violent current surcharges by a
general fuse situated in the power supply panel at the rear of the
stove. Other fuses to protect the electronic boards are situated on
this panel.
SMOKE BLOWER BREAKAGE
If the blower fan stops, the electronic board promptly suspends
the supply of pellets and the alarm is displayed.
GEARED MOTOR BREAKAGE
If the geared motor stops the stove continues to operate until the
minimum cooling level is reached.
BRIEF POWER FAILURE
In the event of a power failure during operation, when the power
returns the stove cools down and then restarts automatically.
FAILED START-UP
If a flame fails to ignite during the start-up phase, the stove alarm
is triggered.
THE SAFETY DEVICES MUST UNDER NO
CIRCUMSTANCES BE TAMPERED WITH
The stove can only be started up after the cause that
triggered the safety system has been identified, thereby
restoring the automatic operation of the sensor. To
troubleshoot the fault, please consult this manual which
illustrates how to remedy it (depending on the error
message displayed by the stove).
CAUTION!
If the stove is NOT used as instructed in this instruction
manual the manufacturer will not be held in any way liable for
any resulting personal harm and/ or property damage. In
addition, the manufacturer will not be held in any way liable
for personal harm and/ or property damage due to failure to
observe all the rules specified in the manual. Also: