MCZ Philo User Manual
Page 23
PELLET STOVES
Chapter 3
USE AND MAINTENANCE MANUAL
page
23
Installation and assembly
Technical dept. - All rights reserved by MCZ Group S.p.A. - Reproduction prohibited
3.5. FITTING THE CLADDING
3.5.1.
Fitting the front panels and grilles
The stove is supplied with the top, grilles and front panels packaged
separately. Therefore, unpack everything before beginning to assemble
the appliance.
A
B
C
D
F
G
E
m
m
Fit the front panels as follows:
Take panel A and fit it into the pins located at the bottom of
the stove. Fasten the panel to the structure using the screws
provided (two screws on the right and two on the left. The
panel must be secured centrally. Open the door and place
two more screws at the bottom). The screws to position in
the centre (underneath the door) are black.
At this point, fasten panel B using the same method. The
panel should fit into the pins on the underpart of the stove
and be fastened to the structure in the central part, under
the door, with two screws (again, black). At the top of the
panel there are two springs that lock into a groove on the
structure.