Epson GT-30000 - Manual (Page 140)

134
Notices
Important Safety Instructions
Read all of these instructions and save them for later reference. Follow all warnings and instructions
marked on the scanner.
■ Unplug the scanner before cleaning. Clean with a damp cloth only. Do not spill liquid on the
scanner.
■ Do not place the scanner on an unstable surface or near a radiator or heat source.
■ Do not block or cover the openings in the scanner’s cabinet. Do not insert objects through the
slots.
■ Use only the type of power source indicated on the scanner’s label.
■ Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as photocopiers or air control systems that regularly switch on and off.
■ Do not let the power cord become damaged or frayed.
■ If you use an extension cord with the scanner, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the total
ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere
rating.
■ Do not attempt to service the scanner yourself.
■ Unplug the scanner and refer servicing to qualified service personnel under the following
conditions: if the power cord or plug is damaged; if liquid has entered the scanner; if the scanner
has been dropped or the cabinet damaged; if the scanner does not operate normally or exhibits a
distinct change in performance. Do not adjust controls that are not covered by the operating
instructions.