Sealey TA320 User Manual

Page 3

Original Language Version

Environmental Protection

Recycle unwanted materials instead of disposing of them as waste.

All tools, accessories and packaging should be sorted, taken to a

recycling centre and disposed of in a manner which is compatible

with the environment.

When the product becomes completely unserviceable and disposal,

drain off any fluids (if applicable) into approved containers and

dispose of the product and the fluids according to local regulations.

WEEE Regulations

Dispose of this product at the end of its working life in compliance

with the EU Directive on Waste Electrical and Electronic Equipment

(WEEE). When the product is no longer required, it must be disposed

of in an environmentally protective way. Contact your local solid waste

authority for recycling information.

Battery Removal

This analyser contains 6 AA batteries which must be disposed of in an

environntally appropriate way.

TO REMOVE THE BATTERIES:

1) Lift the rear support bracket.

2) Remove the four cross-head screws from the battery cover.

3) Remove the battery cover.

4) Remove the batteries.

Under the Waste Batteries and Accumulators Regulations 2009,

Jack Sealey Ltd are required to inform potential purchasers of products

containing batteries (as defined within these regulations), that they are

registered with Valpak’s registered compliance scheme.

Jack Sealey Ltd’s Batteries Producer Registration Number (BPRN) is

BPRN00705.

TA320 Issue No.2(L) 17/06/14

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS,

WARNINGS AND CAUTIONS. USE THIS PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT

IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE

WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.