Sealey TA320 - Manual (Page 27)

4. Press the RANGE/SETUP button until the meter returns to the
normal display to exit this mode.
ALARM LIMITS
1. Press and Hold the SETUP button for two seconds to enter the
High Limit function.
2. Press the
► button to select a digit for adjustment
3. Press the + or – button to adjust the value of the digit
4. Press the
◄
button to turn the alarm OFF.
5. Press the SETUP button and repeat the procedure to set the
low limit
6. Press the SETUP button to step through the other functions
and return to the normal operating mode.
7. The meter will “beep” if the measured value is greater than the
high limit or lower than the low limit.
.
AC+DC
In all the measuring mode VAC,mV(AC),10A(AC),mA(AC),uA(AC),
press button EXIT for 2 seconds to enter into AC+DC testing. The
precision is the same as AC measure. LCD shows AC+DC signal.
Press button EXIT to exit.
LOW BATTERY INDICATION
When the icon appears alone in the display, the batteries
should be replaced.