Epson TOUCH DH200 - Manual (Page 41)

31
Using the Main Menu
UPDATE
Use the Update menu to upgrade system
firmware.
NOTE: The system supports most major
brands of USB flash drives with a capacity
of 10 MB ~ 16 GB.
To upgrade firmware:
1. Download the latest firmware update from
the Digimerge website.
2. Copy the firmware to a blank USB flash
drive.
NOTE: Do not have any folders on the USB
flash drive—just the firmware file.
3. Connect the USB flash drive to the USB
port on the front panel.
4. Stop all recording on the system.
NOTE: You must stop all recording in order
to perform the upgrade.
5. Open the Main Menu and select SYSTEM .
6. Under the UPDATE tab, select UPDATE .
7. Select START and press the ENTER button.
Firmware upgrade begins. Do not remove
the USH flash drive until the upgrade
process is complete.
Do not press any
buttons or power off the system during the
upgrade process.
When upgrade is finished, press the ENTER button
in the prompt window to restart the system.
INFO
View important system information:
• MODEL: The model of the system
• DOMAIN NAME: Your Digimerge DDNS
domain name
• MAC: The physical address of the DVR on
your network
• LANGUAGE: The current system language
• NETWORK: The IP address of the system
• INTERNAL HDD: 1 HDD, size and space
remaining
• USB PORT: The status of the USB port on
the rear panel—will show "NONE" or
"CONNECT"
• MOUSE PORT: The status of the USB
mouse port on the front panel—will show
"NONE" or "CONNECT"
• IDE BUS: The status of the HDD—will show
"GOOD" or "ERROR"
Figure 19.3 Update menu Figure 19.4 System Info menu