Epson Endeavor User Manual
User’s, Guide, Endeavor
Table of contents
Document Outline
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-USING YOUR COMPUTER
- TURNING ON THE COMPUTER
- TURNING OFF THE COMPUTER
- USING DISKS AND DISK DRIVES
- HOW DISK STORE DATA
- TYPES OF DISKETTE DRIVES
- DRIVE AND DISKETTE INCOMPATIBILITIES
- CARING FOR DISKETTES AND DISKETTE DRIVES
- WRITE-PROTECTING DISKETTES
- INSERTING AND REMOVING DISKETTES
- USING A SINGLE DISKETTE DRIVE SYSTEM
- FORMATTING DISKETTES
- MAKING BACKUP COPIES
- USING A HARD DISK DRIVE
- BACKING UP THE HARD DISK
- CARING FOR YOUR HARD DISK
- SPECIAL KEYS ON THE KEYBOARD
- STOPPING A COMMAND OR PROGRAM
- RESETTING THE COMPUTER
- USING A PASSWORD
- CHANGING THE PROCESSOR SPEED
- PREPARING THE HARD DISK FOR MOVING
- USING AUTOEXEC.BAT AND OTHER BATCH FILES
- CHAP 2-INSTALLING AND REMOVING OPTIONS
- HOW TO USE THIS CHAPTER
- REMOVING THE COVER
- CHANGING THE JUMPER SETTINGS
- MEMORY MODULES (SIMMS)
- INSTALLING AN OPTION CARD
- REMOVING AN OPTION CARD
- REMOVING AN OPTION CARD CONNECTOR BOARD
- REPLACING THE OPTION CARD CONNECTOR BOARD
- INSTALLING A NEW PROCESSOR CHIP
- INCREASING THE VIDEO MEMORY
- USING THE ALTERNATE VGA INTERFACE
- USING A DISPLAY ADAPTER CARD
- REPLACING THE COVER
- POST-INSTALLATION PROCEDURES
- CHAP 3-INSTALLING AND REMOVING DRIVES
- HOW TO USE THIS CHAPTER
- SETTING THE HARD DISK DRIVE JUMPERS
- INSTALLING A HARD DISK IN THE VERTICAL BAY
- REMOVING A HARD DISK FROM THE VERTICAL BAY
- INSTALLING A DRIVE IN A HORIZONTAL BAY
- REMOVING A DRIVE FROM A HORIZONTAL BUY
- CONNECTING THE HARD DISK DRIVE RIBBION CABLE TO THE SYSTEM BOARD
- POST-INSTALLATION PROCEDURES
- CHAP 4-RUNNING SYSTEM DIAGNOSTICS
- CHAP 5-FORMATTING A HARD DISK
- CHAP 6-TROUBLESHOOTING
- APPENDIX A-SPECIFICATIONS
- GLOSSARY
- INDEX