Epson Endeavor User Manual
Page 106
Connecting the Hard Disk Drive Ribbon Cable to
the System Board
Follow these steps to connect the hard disk drive ribbon cable
to the system board:
1. Locate the hard disk drive connector on the system board.
As shown below, it is next to the diskette drive connector,
between the option card connector board and the power
supply. (The diskette drive ribbon cable is removed from
the illustration for clarity.)
Installing and Removing Drives
3-33
See also other documents in the category Epson Computers:
- ACTIONPC 5000 (12 pages)
- EQUITY 386SX/16 PLUS (261 pages)
- 20040 (251 pages)
- EQUITY 386SX/20 PLUS (6 pages)
- S1C33210 (559 pages)
- 3865X Plus (337 pages)
- 2000 (231 pages)
- 2000 (129 pages)
- 486SX (233 pages)
- EISA Desktop (184 pages)
- 386 (218 pages)
- Equity 286 PLUS (263 pages)
- 10020 (238 pages)
- Equity II (151 pages)
- Equity II (79 pages)
- EQUITY Y14499113001 (139 pages)
- Equity 320SX PLUS (230 pages)
- EL 3S/33 (117 pages)
- EQUITY 3865X/20 PLUS (269 pages)
- Endeavor 468C (187 pages)
- Equity Ie Q50188015-1 (147 pages)
- LT-286 (188 pages)
- 386/25 (326 pages)
- 386SX (284 pages)
- Endeavor power (SPEED) hard disk diskette WG (8 pages)
- 486 UC+ (9 pages)
- Endeavor WG (201 pages)
- S1C63000 (152 pages)
- I+ (139 pages)
- LT - 286e (60 pages)
- LT - 286e (161 pages)
- 486SX EN (6 pages)