Staring the program, Starting the program – Epson Endeavor User Manual
Page 120
Starting the Program
Follow these steps to start the hard disk formatting program:
1. Insert the Reference diskette in drive A and log onto drive A.
2.
Type
HDFMTALL
and press
You see the Hard Disk
Format Menu:
1 - Format
2
-
Destructive surface
a n a l y s i s
3
- Non-destructive surface analysis
0
- Exit
The option you choose depends on whether you are
formatting a new disk or reformatting a used disk. The
options work as follows:
Format
first scans the disk for defective (bad) tracks (if
it has no defective track table) and lets you decide
which tracks to mark as bad. Then it formats the disk
and marks the bad tracks so they are never used to
store data.
Destructive surface analysis
tests the entire
disk for read/write errors or unflagged bad tracks and
updates the defective track table. Because this option
writes and reads data on the disk, it destroys all data on
any track that produces an error. Y
OU
cannot run this test
on a disk that has never been formatted.
Non-destructive surface analysis
checksthe
disk for unflagged bad tracks without destroying data.
You cannot run this test on a disk that has never been
format
ted.
5-2
Formatting a Hard Disk