Epson Endeavor User Manual

Page 143

If you are running an application program, see if you need

to set up the program for the type of monitor and display

adapter you have. Also make sure you are using the

appropriate monitor and display adapter for your software.

Note

If your application program requires a monitor that

supports graphics but you have a monochrome monitor,

the results will be unpredictable.

If you installed a display adapter card (and did not connect it

to the feature connector on the main system board), you

must set jumper J6 to disable the built-in VGA adapter or

you will not see anything on the screen. See “Changing the

Jumper Settings” in Chapter 2 for instructions.

If you still have difficulty with your monitor, run the Video

adapter diagnostic tests described in Chapter 4. If the

diagnostics program indicates an error, contact the

representative who sold you the monitor.

6-14 Troubleshooting