Epson Endeavor - Manual (Page 39)

Using a Password
If you set a System Access password when you ran the SETUP
program, you must enter it every time you turn on or reset the
computer. Follow these steps to use your password:
1. If you do not have a hard disk, insert your system diskette
in drive A.
2. Turn on or reset the computer. You see the following prompt:
Enter Password:
3. Type your password. You see an asterisk for each character
you type. Then press
After you type the password correctly and press the
computer loads the operating system and displays the
command prompt.
Note
If you do not know the correct password, see “Password
Problems” in Chapter 6.
Changing
or Deleting
a Password
To change or delete your password, you must run the SETUP
program and follow the instructions for entering a password in
Chapter 2 of the Setup Guide.
If you do not know your password, see “Password Problems”
in Chapter 6.
Using Your Computer 1-23