Emerson Process Management Bristol ControlWave ExpressPAC User Manual
Controlwave expresspac, Process automation controller / remote terminal, Unit)
Table of contents
Document Outline
- COV
- IMPORTANT INSIDE FRONTCOVER
- TRAINING PAGE
- TOC
- CH1
- CH2
- Chapter 2 – Installation
- 2.1 Site Considerations
- 2.2 Installation Overview
- 2.3 Configuring the CPU/System Controller Board
- 2.3.1 Setting DIP Switches on the CPU/System Controller Board
- 2.3.2 Setting Jumpers on the CPU/System Controller Board
- 2.3.3 General Wiring Guidelines
- 2.3.4 Wiring Power to the CPU/System Controller Board
- 2.3.5 Mounting the Solar Panel
- 2.3.6 Connections to RS-232 Serial Port(s) on the CPU/System Controller Board
- 2.3.7 Connections to the COM3 (RS-485/RS-232) Serial Port on the CPU/System Controller Board
- 2.3.8 Connections to the Ethernet Port on the CPU/System Controller Board
- 2.4 Radios and Modems
- 2.5 Optional Display/Keypads
- Chapter 2 – Installation
- CH3
- Chapter 3 – I/O Configuration and Wiring
- 3.1 I/O Options
- 3.2 Process I/O Board
- 3.3 I/O Wiring
- 3.3.1 Non-Isolated Discrete Inputs (DI) on TB2 and TB3 of Process I/O Board
- 3.3.2 Non-Isolated Discrete Outputs (DO) on TB3 of Process I/O Board
- 3.3.3 Non-Isolated Analog Inputs (AI) on TB6 of Process I/O Board
- 3.3.4 Non-Isolated Analog Output (AO) on TB7 of Process I/O Board
- 3.3.5 Non-Isolated Pulse Counter/Discrete Inputs on TB5 of CPU/System Controller Board
- 3.3.6 Non-Isolated High Speed Counter (HSC) / Discrete Inputs (DI) on TB4 of Process I/O Board
- 3.3.7 Resistance Temperature Device (RTD) Inputs on CPU/System Controller Board
- 3.3.8 Connections to a Bristol Model 3808 Transmitter
- Chapter 3 – I/O Configuration and Wiring
- CH4
- CH5
- Chapter 5 – Service and Troubleshooting
- 5.1 Upgrading Firmware
- 5.2 Removing or Replacing Components
- 5.2.1 Accessing Modules for Testing
- 5.2.2 Removing/Replacing the CPU/System Controller Board and the Process I/O Board
- 5.2.3 Removing/Replacing the Primary Battery System
- 5.2.4 Removing/Replacing the Backup Battery
- 5.2.5 Enabling / Disabling the Backup Battery
- 5.2.6 Removing/Replacing the Case-Mounted Radio or Modem
- 5.3 General Troubleshooting Procedures
- 5.4 Core Updump
- 5.5 Calibration Checks
- Chapter 5 – Service and Troubleshooting
- APA
- APZ
- IDX
- RCV