Emerson Process Management Bristol ControlWave ExpressPAC - Manual (Page 18)

ControlWave ExpressPAC Instruction Manual (CI-ControlWave EPAC)
2-4 Installation Revised Mar-2011
b) Enabling the backup battery by setting jumper W3 on the
CPU/System Controller board to position 1 to 2. (See Section
2.3.2)
b) Setting switches and jumpers on the CPU/System Controller
board (see Section 2.3.1 and Section 2.3.2) and on the Process
I/O board (see Section 3.2.1 and Section 3.2.2) and placing both
boards (as a single assembly) into the chassis.
d) Connecting communication cables, including a cable to a 3808
transmitter, if required. (See Sections 2.3.6, 2.3.7, 2.3.8, and
3.3.8.)
e) Wiring I/O. (See Section 3.3)
f) Installing a ground wire between the enclosure ground lug and a
known good Earth ground. (See Section 2.2.2)
g) Connecting the RTD probe (if required). (See Section 3.3.7)
h) Installing the solar panel and rechargeable battery (if
applicable).(See Section 2.3.5)
i) Wiring power to the unit. (See Section 2.3.4)
j) Turning on power. (See Section 4.1)
2. Installing PC-based software (ControlWave Designer).
3. Establishing communications.
4. Creating an application-specific control strategy (ControlWave
project).
5. Creating application-specific web pages (optional).
6. Adding the ControlWave ExpressPAC to an OpenBSI network.
7. Downloading the application-specific ControlWave project into the
ControlWave ExpressPAC.
Note
: Steps 2 through 7 require that you install and use ControlWave
Designer software on your PC. This manual focuses on hardware
installation and preparation. Software installation and
configuration is beyond the scope of this manual. Refer to the
Getting Started with ControlWave Designer Manual (D5085)
and the ControlWave Designer Programmer’s Handbook
(D5125) for material related to software installation and use.
2.2.1 Mounting the Housing
 You must position the ControlWave ExpressPAC vertically. See
Figure 2-2 for enclosure dimensions.
 Make sure the front of the assembly is visible and you can open the
front cover for service, installation, and so on. Ensure you can
clearly see and use the optional LCD display/keypad.