Resuming from an error, Do you want a printout of the error – Epson Equity Ie Q50188015-1 User Manual
Page 92
Resuming From an Error
If an error occurs during a test, the test stops at that point and an error code
and error message are displayed. If you want to record the problem, you can
print out the message on your printer. You see this prompt:
Do you want a printout of the error
message(s)
(Y/N)?
To continue without printing the error message, press
N
and
Enter.
To request a printout, first make sure your printer is turned on and on-line,
with paper loaded. Then press Y and
Enter.
If the printer is not ready, the
following message is displayed:
Printer is not installed correctly.
Install correctly and enter Y, or
Enter N to cancel printing.
Correct the problem and press Y and
Enter
to continue printing, or press
N
and
Enter
to cancel printing.
After printing the error message, the program displays this prompt:
Printout is finished. Press Enter to return to
the menu.
The program continues after an error in one of the following ways:
l
It returns to the DEVICE LIST, or
l
If you are running multiple tests and are not terminating on an error,
the program repeats the test that caused the error.
The remainder of this appendix describes the tests you can run on the
system’s internal devices and on the optional devices installed in or
connected to your computer. The program displays the titles of each test on
the screen.
For a complete list of the error codes and messages that are displayed by
these tests, see the table at the end of this appendix.
D-4
Performing
System
Diagnostics