Epson Equity Ie Q50188015-1 - Manual (Page 67)

Running MENU from a diskette
If you are running the MENU utility from a diskette rather than a hard
disk, when you select a specific operation the screen displays a message
similar to this:
MODE.COM is not on the current disk or PATH
Press any key to continue...
At this point you need to switch to the Startup/Operating 1 diskette for the
remainder of the operation. Remove the Operating 2 diskette from drive A
and replace it with the Startup/Operating 1 diskette and then press any key.
The screen that was displayed before reappears and you can continue the
operation.
There are two alternatives to the disk-swapping described above:
l
Create a MENU diskette containing all the files necessary to run the
MENU utility. To do this, you need to understand more about how the
MENU utility is structured. See your MS-DOS manual for details.
l
Before you run the MENU program, type PATH B : at the A > prompt
and press Enter. Then when you run the MENU program, the screen
prompts you when to insert the diskette for drive B. At that point,
insert the Startup/Operating 1 diskette in drive A if you have only one
drive or drive B if you have two drives. Press any key to continue.
MENU utility options
Below is a description of what each option does. Step-by-step instructions for
using each option are provided in your MS-DOS manual.
File Utilities
Lets you back up and restore files, replace files,
compare files, change file attributes, copy files,
and copy directories. This option does the
work of these MS-DOS commands: BACKUP
RESTORE, REPLACE, FC, ATTRIB, and
XCOPY.
DiskUtilities
Lets you check, copy, compare, and format
diskettes. This option provides an easy-to-use
4-20 Using MS-DOS with Your Equity Ie