Epson Equity Ie Q50188015-1 User Manual

Page 4

FCC COMPLIANCE STATEMENT

FOR AMERICAN USERS

This equipment generates and uses radio frequency energy and if not installed and
used properly, that is, in strict accordance with the manufacturer’s instructions, may

cause interference to radio and television reception. It has been type tested and found

to comply with the limits for a Class B computing device in accordance with the

specifications in Subpart J of Part 15 of FCC rules, which are designed to provide

reasonable protection against such interference in a residential installation. However,

there is no guarantee that interference will not occur in a particular installation. If this

equipment does cause interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to

correct the interference by one or more of the following measures:

Reorient the receiving antenna

Relocate the computer with respect to the receiver

Move the computer away from the receiver

Plug the computer into a different outlet so that the computer and receiver are on

different branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television
technician for additional suggestions. The user may find the following booklet prepared

by the Federal Communications Commission helpful:

“Television Interference Handbook”

This booklet is available from the U.S. Government Printing Office, Washington DC

20402.

Stock No. 004-000-00450-7.

Note:

If the interference stops, it was probably caused by the computer or its

peripheral devices. To further isolate the problem:

Disconnect the peripheral devices and their input/output cables one at a time.
If the interference stops, it is caused by either the peripheral device or its I/O
cable. These devices usually require shielded I/O cables. For Epson peripheral
devices, you can obtain the proper shielded cable from your dealer. For non-

Epson peripheral devices contact the manufacturer or dealer for assistance.

WARNING

This equipment has been certified to comply with the limits for a Class B
computing device, pursuant to Subpart

of Part

of FCC Rules. Only

peripherals (computer input/output devices, terminals, printers, etc.)
certified to comply with the Class B limits may be attached to this
computer. Operation with non-certified peripherals is likely to result in
interference to radio and TV reception.

The connection of a non-shielded equipment interface cable to this

equipment will invalidate the FCC Certification of this device and may

cause interference levels which exceed the limits established by the FCC for
this equipment.

. . .

111