Copying the reference and operating 2 files, Enter, Preparing hard disk for use 2-5 – Epson Equity Ie Q50188015-1 User Manual
Page 34
When all the files are copied, the A > prompt reappears. The SELECT
procedure is complete.
Note
The SELECT command copies all the MS-DOS files on the Startup/
Operating 1 diskette. However, to use the complete operating system as
described in this manual and in your MS-DOS manual, you also need to
copy the files on the Operating 2 and Reference diskettes to your hard
disk. See the next section for instructions.
These procedures copy files to the root directory of drive C. You may,
however, want to store these files in separate subdirectories so they are
easier to find. For information on subdirectories, see Chapter 4 of this
manual and also your MS-DOS manual.
Copying the Reference and Operating 2 Files
Follow the instructions below to copy the files on your Operating 2 and
Reference diskettes to the hard disk. If you want to store the files in a
separate subdirectory, see Chapter 4 for instructions.
.
1. Remove the MS-DOS diskette from drive A and insert the Operating 2
diskette in the drive.
2. You should still be logged on to drive A. If not, type A : and press
Enter.
3. At the A> prompt, type the following and press
Enter:
C O P Y * . * c :
MS-DOS copies all the files from the diskette to your hard disk. The file
names appear on the screen as they are copied.
4. After copying, remove the Operating 2 diskette from drive A and insert
the Reference diskette. Type the following and press
Enter:
C O P Y * . * c :
5. When the copying is complete, store your diskettes in a safe place.
Preparing Hard Disk for Use
2-5