beautypg.com

Unconditional format, Do you want default interleave of 3 (y/n), Enter interleave factor (1-16) – Epson Equity Ie Q50188015-1 User Manual

Page 119

background image

If you want to format the disk after receiving this error message, do the

following:

1. If the drive is not formatted, run the Unconditional format (option 2)

and enter any tracks you know are bad in the Bad Track Table. (See

“Unconditional Format” below.)

2. Run the Destructive surface analysis (option 3) to flag any remaining bad

tracks. (See “Destructive Surface Analysis,” below.)

3. Run the Conditional format again. No errors should occur; if one does,

contact your dealer.

Unconditional Format

Use this option to format your hard disk when you want to enter the list of

bad tracks before formatting. The main difference between unconditional

and conditional formatting is the way in which bad tracks are identified.

With the unconditional format, you must enter the list of bad tracks before
formatting begins.

To start the Unconditional format routine, press 2 and then

Enter.

You are first given the option to change the interleave factor for formatting

from the default value of three. Only do this if the documentation with your

hard disk recommends a different value. You see this prompt:

Do you want default interleave of 3 (Y/N)?

To accept the default, press Y and

Enter.

To change the value, press

N

and

Enter.

You see this prompt:

Enter interleave factor (1-16):

Type the recommended value, and press

Enter.

F-6

Formatting a User-installed Hard Disk