Epson Equity Ie Q50188015-1 - Manual (Page 28)

Press Y so you can make a copy of the Operating 2 diskette. Remove the
diskettes from drives A and B by pressing the release buttons on each
drive. Then insert the Operating 2 diskette in drive A and another
blank diskette in drive B. Follow the prompts on the screen to copy the
Operating 2 diskette.
6. Now follow the procedure described in Step 5 to copy the Reference.”
diskette.
7. When you finish and the
Copy another diskette (Y/N) ?
prompt is displayed, press N to return to the MS-DOS command
prompt.
Copying with one diskette drive
1. Insert the Startup/Operating 1 diskette in drive A if it is not there
already
2. Type DISKCOPY and press Enter. The screen displays this message:
Insert SOURCE diskette in drive A:
Press any key when ready . . .
3. Drive A already contains the diskette you want to copy (the source
diskette), so just press any key The DISKCOPY program copies the
contents of the diskette to the computer’s memory.
Note
Because the 720KB MS-DOS diskette holds more data than fits in the
computer’s 640KB of memory, the computer copies the contents of the
diskette in two passes. The screen prompts you when to insert and
remove the diskettes.
The screen then displays this message:
Insert TARGET diskette in drive A:
Press any key when ready . . .
4. Remove the Startup/Operating 1 diskette from drive A by pressing the
release button and insert the blank diskette (the target diskette) in the
drive. Then press any key.
Setting Up Your System 1-15