Yaskawa V1000 Option Dual Port EtherNet/IP SI-EN3D/V Technical Manual - Manual (Page 7)

2 Product Overview
u About this Product
The option provides a communications connection between the drive and an ODVA EtherNet/IP network. The option connects
the drive to an EtherNet/IP network and facilitates the exchange of data.
This manual explains the handling, installation and specifications of this product.
EtherNet/IP is a communications link to connect industrial devices (such as smart motor controllers, operator interfaces, and
variable frequency drives) as well as control devices (such as programmable controllers and computers) to a network. EtherNet/
IP is a simple, networking solution that reduces the cost and time to wire and install factory automation devices, while providing
interchangeability of like components from multiple vendors.
EtherNet/IP is an open device network standard.
By installing the option to a drive, it is possible to do the following from an EtherNet/IP master device:
• Operate the drive
• Monitor drive status
• Change drive parameter settings.
u Applicable Models
The option can be used with the drive models in Table 1 .
Table 1 Applicable Models
Drive Series Drive Model Number Software Version <1>
V1000 CIMR-VooAoooo 1012 and later
<1> See “PRG” on the drive nameplate for the software version number.
2 Product Overview
YASKAWA SIEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Technical Manual 7