Yaskawa V1000 Option Dual Port EtherNet/IP SI-EN3D/V Technical Manual - Manual (Page 25)

u Speed and Torque Control Output - 22 (0x16)
Output Instance Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
22
0
0 – – – – – Fault Reset – Run Fwd
1 –
1
2 Speed Reference (Low Byte)
3 Speed Reference (High Byte)
2
4 Torque Reference (Lower Byte), not supported
5 Torque Reference (High Byte), not supported
Name Description
Run Fwd
Forward Run Command
0: Stop
1: Forward Run
Fault Reset
Fault Reset
(0 to 1 transition: Fault Reset)
Speed Reference
Speed Command
Sets drive speed reference.
Speed reference data: Frequency reference/2 SS (SS: Speed scale)
Setting range: 0 to 0xFFFF
Example: setting a reference of 4096 with a speed scale of 2:
Speed reference data = 4096/2 2 = 1024 = 0x0400 Hex
Unit depends on o1-03.
Torque Reference Not supported
u Extended Speed and Torque Control Output - 23 (0x17)
Output Instance Word Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
23
0
0 – NetRef NetCtrl – – Fault Reset Run Rev Run Fwd
1 –
1
2 Speed Reference (Low Byte)
3 Speed Reference (High Byte)
2
4 Torque Reference (Lower Byte), not supported
5 Torque Reference (High Byte), not supported
Name Description
Run Fwd
Forward Run Command
0: Stop
1: Forward Run
Run Rev
Reverse Run Command
0: Stop
1: Reverse Run
Fault Reset
Fault Reset
(0 to 1 transition: Fault Reset)
NetCtrl
Run command from Network
0: Depends on b1-02
1: Enables the run command from network
NetRef
Speed reference from Network
0: Depends on b1-01
1: Enables the speed reference from network
Speed Reference
Speed Command
Sets drive speed reference.
Speed reference data: Frequency reference/2 SS (SS: Speed scale)
Setting range: 0 to 0xFFFF
Example: setting a reference of 4096 with a speed scale of 2:
Speed reference data = 4096/2 2 = 1024 = 0x0400 Hex
Unit depends on o1-03.
Torque Reference Not supported
8 Output Assemblies (Drive Consumes)
YASKAWA SIEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Technical Manual 25