Yaskawa V1000 Option Dual Port EtherNet/IP SI-EN3D/V Technical Manual - Manual (Page 16)

Ground terminal
Ground wire
Drive ground terminal/
NEMA Type 1 conduit
bracket screw
Ground wire
Drive-side
connector
Screw size:
M3.5 to M6
Option unit
connector
Screw size: M3
Figure 11 Reattach the NEMA Type 1 Conduit Bracket and Connect the Ground Wire
(Models BA0001F to BA0003F and 2A0001F to 2A0006F)
9.
Reattach the bottom cover. Keep the ground wire inside of the bottom cover when reattaching.
IP20/Open-Chassis IP20/NEMA Type 1 Enclosure
Figure 12 Reattach the Bottom Cover
10.
On models BA0006 to BA0018, 2A0008 to 2A0069, and 4A0001 to 4A0038, reattach the terminal cover.
Refer to
Figure 13 and Figure 14 for drive models BA0006 to BA0018, 2A0008 to 2A0020, and 4A0001 to 4A0011,
which require routing the ground wire through the provided notch when reinstalling the terminal cover.
Figure 13 Reattach the Terminal Cover
(Models BA0006 to BA0018; 2A0008 to 2A0069; 4A0001 to 4A0038)
5 Installation Procedure
16 YASKAWA SIEP YAICOM 15A V1000 Option Dual-Port EtherNet/IP SI-EN3D/V Technical Manual