SMA MATRIX - Manual (Page 16)

Assembly SMA Solar Technology AG
16 SMatrix-BEN095014 User Manual
5 Assembly
5.1 Safety during Mounting
5.2 Requirements for the Mounting Location
Please note the following requirements for the mounting location:
• The Sunny Matrix is suitable for both indoor and outdoor installation.
• The Sunny Matrix requires a plug socket (100 V AC to 240 V AC) for the power supply.
– The electricity cable is not suitable for use outdoors. Replace the electricity cable before
mounting with an electricity cable suitable for use outdoors.
– The electricity cable is 1.70 m long. If the electricity cable is too short, replace it with a longer
one before mounting.
How to replace the electricity cable is described in section 9.1.1 ”Replacing electricity cable”
(page 61).
• The Sunny Matrix requires an Ethernet network connection. The Sunny Matrix patch cable is ca.
2.70 m long and is suitable for both indoor and outdoor use. If the patch cable is too short,
extend it before mounting or replace it with a suitably long patch cable. How to extend or
replace the patch cable is described in section 9.1.2 ”Replacing or extending the patch cable”
(page 63).
• The load bearing capacity of the wall must be sufficient for the selected methiod of mounting.
• Select a surface that is suitable for the weight of the Sunny Matrix. The weight of the Sunny
Matrix is dependent on its dimensions (W/H/D):
– 800 mm x 400 mm x 120 mm = 15 kg
– 800 mm x 800 mm x 120 mm = 20 kg
– 800 mm x 1.000 mm x 120 mm = 25 kg
• The screws and wall anchors provided are standard materials, and not suitable for every
surface. Use fastening materials that are suitable for the surface and the weight of the Sunny
Matrix.
CAUTION!
Danger of injury due to heavy weight (25 kg) of the Sunny Matrix with the
dimensions 800 mm x 1000 mm x 120 mm.
• Transport the Sunny Matrix with two people or with a cart.
• Mount the Sunny Matrix with at least two people.