SMA STP 60-US-10 Installation - Manual (Page 42)

4 Service SMA Solar Technology AG
42 STP60-10-IA-xx-10 Installation Guide
Table 4.3 System-related events
Internal events
2054 Transmitting the grid code from
SMA Inverter Manager to
STP 60-10 failed. If the occurs repeatedly, contact
the Service. - - -
ID Status
message Description Measure DGO Hotline PV
ID Status
message Description Measure DGO Hotline PV
201 to
208 The internal temperature of the
inverter is too high. Make sure that there are no
objects or dust on the inverter and
that the air duct is not blocked. - - -
209,
210 Voltage in DC link is too high. If the event persists, reset the
inverter by disconnecting DC and
AC. If the event is repeated, check
the maximum PV voltage using the
display to see if it is above the
limits.
- - -
211 Low fan
speed Fan speed is too low. Check whether the inverter fan is
blocked. - - -
213 to
215 Internal error. Voltage
measured before and after the
relay differs too much. Contact the Service. - - -
216 to
218 Current measured on AC side
is too high. Contact the Service. - - -
219 to
221 Internal error. Voltage
measured before and after the
relay differs too much. Contact the Service. - - -
225 to
240,
275 Failure in memory/EEPROM. Restart the inverter. If the event
persists, call the Service. - - -
241,
242,
245,
249 Internal communications fault. Restart the inverter. If the event
persists, call the Service.
- - -
248 Internal CPU error. Restart the inverter. If the event
persists, call the Service. - - -
252 to
254 Current measured on AC side
is too high. If the event repeats, call Service. - - -
243,
263 Internal error. Restart the inverter. If the event
persists, call the Service. - - -
279 Temperature sensor error. If the event persists, call the
Service. - - -