HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 74)

74 Introduction
2.3 Oper
ating Modes
Program Run, Full Sequence and Program Run,
Single Block
In the Program Run, Full Sequence mode of operation the TNC
executes a part program continuously to its end or to a manual or
programmed stop. You can resume program run after an interruption.
In the Program Run, Single Block mode of operation you execute each
block separately by pressing the machine START button.
Soft keys for selecting the screen layout
Soft keys for selecting the screen layout for pallet tables
Window Soft key
Program
Left: program, right: program structure
Left: program, right: status
Left: program, right: graphics
Graphics
Left: program blocks, right: active collision
objects (FCL4 function). If this view is selected,
then the TNC indicates a collision with a red
frame around the graphics window.
Active collision objects (FCL4 function). If this
view is selected, then the TNC indicates a
collision with a red frame around the graphics
window.
Window Soft key
Pallet table
Left: program blocks, right: pallet table
Left: pallet table, right: status
Left: pallet table, right: graphics