HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 400)

400 Programming: Special Functions
1
1
.8 W
o
rk
ing with Cut
ting D
a
ta T
a
bles
Working with automatic speed / feed rate
calculation
1 If it has not already been entered, enter the type of workpiece
material in the file WMAT.TAB.
2 If it has not already been entered, enter the type of cutting material
in the file TMAT.TAB.
3 If not already entered, enter all of the required tool-specific data in
the tool table:
„ Tool radius
„ Number of teeth
„ Tool type
„ Tool material
„ The cutting data table for each tool
4 If not already entered, enter the cutting data in any cutting data
table (CDT file).
5 Test Run operating mode: Activate the tool table from which the
TNC is to take the tool-specific data (status S).
6 In the NC program, set the workpiece material by pressing the
WMAT soft key.
7 In the NC program, let the T block automatically calculate the
spindle speed and feed rate via soft key.