HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 491)

HEIDENHAIN iTNC 530 491
14.6 Using the 3-D T
o
uc
h Pr
obe
14.6 Using the 3-D Touch Probe
Overview
The following touch probe cycles are available in the Manual Operation
mode:
Note that HEIDENHAIN generally does not accept liability
for the function of the touch probe cycles unless you use
HEIDENHAIN touch probes!
Function Soft key Page
Calibrating the effective length Page 496
Calibrating the effective radius Page 497
Measuring a basic rotation using a line Page 501
Setting the datum in any axis Page 505
Setting a corner as datum Page 506
Setting a circle center as datum Page 507
Setting a center line as datum Page 508
Measuring a basic rotation using two
holes/cylindrical studs Page 509
Setting the datum using four
holes/cylindrical studs Page 509
Setting a circle center using three
holes/cylindrical studs Page 509