HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 561)

HEIDENHAIN iTNC 530 561
1
7.1 Selecting MOD F
unctions
Overview of MOD functions
The functions available depend on the momentarily selected operating
mode:
Programming and Editing:
„ Display software numbers
„ Enter code number
„ Set data interface
„ Diagnostic functions, if applicable
„ Machine-specific user parameters, if applicable
„ Display HELP files (if provided)
„ Select machine kinematics, if applicable
„ Load service packs
„ Set the time zone
„ Start file-system check
„ Configure the HR 550 wireless handwheel
„ License info
„ Host computer operation
Test run:
„ Display software numbers
„ Enter code number
„ Set the data interface
„ Show the workpiece in the working space
„ Machine-specific user parameters, if applicable
„ Display HELP files (if provided)
„ Select machine kinematics, if applicable
„ Set 3-D ROT function, if applicable
„ Set the time zone
„ License info
„ Host computer operation
In all other modes:
„ Display software numbers
„ Display code digits for installed options
„ Select position display
„ Define unit of measurement (mm/inches)
„ Set the programming language for MDI
„ Select the axes for actual position capture
„ Set the axis traverse limits
„ Display reference points
„ Display operating times
„ Display HELP files (if provided)
„ Set the time zone
„ Select machine kinematics, if applicable
„ License info