HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 37)

HEIDENHAIN iTNC 530 37
12.1 Functions for Multiple Axis Machining ..... 404
12.2 The PLANE Function: Tilting the Working Plane (Software Option 1) ..... 405
Introduction ..... 405
Define the PLANE function ..... 407
Position display ..... 407
Reset the PLANE function ..... 408
Defining the machining plane with space angles: PLANE SPATIAL ..... 409
Defining the machining plane with projection angles: PROJECTED PLANE ..... 411
Defining the machining plane with Euler angles: EULER PLANE ..... 413
Defining the working plane with two vectors: VECTOR PLANE ..... 415
Defining the machining plane via three points: PLANE POINTS ..... 417
Defining the machining plane with a single, incremental spatial angle: PLANE RELATIVE ..... 419
Tilting the working plane through axis angle: PLANE AXIAL (FCL 3 function) ..... 420
Specifying the positioning behavior of the PLANE function ..... 422
12.3 Inclined-Tool Machining in the Tilted Plane ..... 427
Function ..... 427
Inclined-tool machining via incremental traverse of a rotary axis ..... 427
12.4 Miscellaneous Functions for Rotary Axes ..... 428
Feed rate in mm/min on rotary axes A, B, C: M116 (software option 1) ..... 428
Shorter-path traverse of rotary axes: M126 ..... 429
Reducing display of a rotary axis to a value less than 360°: M94 ..... 430
Automatic compensation of machine geometry when working with tilted axes: M114 (software option 2) ..... 431
Maintaining the position of the tool tip when positioning with tilted axes (TCPM): M128 (software
option 2) ..... 433
Exact stop at corners with nontangential transitions: M134 ..... 436
Selecting tilting axes: M138 ..... 436
Compensating the machine’s kinematics configuration for ACTUAL/NOMINAL positions at end of block: M144
(software option 2) ..... 437
12.5 Peripheral milling: 3-D radius compensation with workpiece orientation ..... 438
Function ..... 438
12 Programming: Multiple Axis Machining ..... 403