HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 63)

HEIDENHAIN iTNC 530 63
1
.6 W
o
rk
piece Set
u
p Align the workpiece with a 3-D touch probe
system
U Insert the 3-D touch probe: In the Manual Data Input (MDI) operating
mode, run a TOOL CALL block containing the tool axis, and then return
to the Manual Operation mode (in MDI mode you can run an
individual NC block independently of the others)
U Select the probing functions: The TNC displays the
available functions in the soft-key row
U Measure the basic rotation: The TNC displays the
basic rotation menu. To identify the basic rotation,
probe two points on a straight surface of the
workpiece
U Use the axis-direction keys to pre-position the touch
probe to a position near the first contact point
U Select the probing direction via soft key
U Press NC start: The touch probe moves in the defined
direction until it contacts the workpiece and then
automatically returns to its starting point.
U Use the axis-direction keys to pre-position the touch
probe to a position near the second contact point
U Press NC start: The touch probe moves in the defined
direction until it contacts the workpiece and then
automatically returns to its starting point
U Then the TNC shows the measured basic rotation
U Press the END key to close the menu and then
answer the question of whether the basic rotation
should be transferred to the preset table by pressing
the NO ENT key (no transfer)
Further information on this topic
„ MDI operating mode: See “Programming and Executing Simple
Machining Operations” on page 522
„ Workpiece alignment: See “Compensating Workpiece
Misalignment with a 3-D Touch Probe” on page 499