HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 539)

HEIDENHAIN iTNC 530 539
16.3 T
e
st Run
16.3 Test Run
Application
In the Test Run mode of operation you can simulate programs and
program sections to reduce programming errors during program run.
The TNC checks the programs for the following:
„ Geometrical incompatibilities
„ Missing data
„ Impossible jumps
„ Violation of the machine’s working space
„ Collisions between collision-monitored components (DCM software
option is required, see "Collision monitoring in the Test Run mode of
operation", page 354)
The following functions are also available:
„ Blockwise test run
„ Interrupt test at any block
„ Optional block skip
„ Functions for graphic simulation
„ Calculating the machining time
„ Additional status display
If your machine has the DCM (Dynamic Collision
Monitoring) software option, you can check for collisions
in the Test Run mode before actually machining a part,
(see “Collision monitoring in the Test Run mode of
operation” on page 354)