HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 591)

HEIDENHAIN iTNC 530 591
1
7.1
9 T
e
leService
17.19 TeleService
Application
The TNC allows you to carry out TeleService. To be able to use this
feature, your TNC should be equipped with an Ethernet card which
achieves a higher data transfer rate than the serial RS232-C interface.
With the HEIDENHAIN TeleService software, your machine tool
builder can then establish a connection to the TNC via an ISDN modem
and carry out diagnostics. The following functions are available:
„ On-line screen transfer
„ Polling of machine states
„ Data transfer
„ Remote control of the TNC
Calling/exiting TeleService
U Select any machine mode of operation
U Press the MOD key to select the MOD function.
U Establish a connection to the service agency: Set the
SERVICE or SUPPORT soft key to ON. The TNC
breaks the connection automatically if no new data
have been transferred for a time set by the machine
tool builder (default: 15 min)
U To break the connection to the service agency: Set the
SERVICE or SUPPORT soft key to OFF. The TNC
terminates the connection after approx. one minute
The TeleService functions are enabled and adapted by the
machine tool builder. Refer to your machine tool manual
for more information.
The TNC provides two soft keys for TeleService, making it
possible to configure two different service agencies.