HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 200)

200 Programming: Tools
5.2 T
ool D
a
ta
Delete marked tool data
You can use this function you can simply delete tool data that you no
longer need.
Follow the steps outlined below for deleting:
U In the tool management you use the arrow keys or mouse to mark
the tool data that you wish to delete
U Select the DELETE MARKED TOOLS soft key and the TNC shows a
pop-up window listing the tool data to be deleted
U Start the delete procedure with the START soft key: The TNC shows
the status of the delete procedure in a pop-up window
U Terminate the delete procedure by pressing the END key or soft key
„ The TNC deletes all the data of all the tools selected.
Make sure that you really no longer need the tool data,
because there is no Undo function available.
„ You cannot delete the tool data of tools still stored in
the pocket table. First remove the tool from the
magazine.