HEIDENHAIN iTNC 530 (606 42x-02) ISO programming - Manual (Page 50)

50 First Steps with the iTNC 530
1
.3 Pr
ogr
amming the First P
a
rt 1.3 Programming the First Part
Select the correct operating mode
You can write programs only in the Programming and Editing mode:
U Press the operating modes key: The TNC goes into
the Programming and Editing mode
Further information on this topic
„ Operating modes: See “Programming and Editing” on page 73
The most important TNC keys
Further information on this topic
„ Writing and editing programs: See “Editing a program” on page 102
„ Overview of keys: See “Controls of the TNC” on page 2
Functions for conversational guidance Key
Confirm entry and activate the next dialog
prompt
Ignore the dialog question.
End the dialog immediately.
Abort dialog, discard entries.
Soft keys on the screen with which you select
functions appropriate to the active state