HEIDENHAIN ND 1200R - Manual (Page 50)

50 2 Installation and Specifications
2.2 Har
d
w
a
re
Installation
2.2 Hardware Installation
The ND 1200R is easy to install. This section describes how to install
the ND 1200R hardware.
Assembling the mounting stand
The ND 1200R is secured to the swivel slots of the mounting stand by
a shoulder screw, a cap screw and associated washers.
 Assemble the ND 1200R to the mounting stand as shown on the
right
 Tighten the shoulder screw ( 1 ).
 Tighten the cap screw ( 5 ) and washers ( 3 & 4 ) enough so that the
ND 1200R will be secure when adjusted to the desired tilt position.
 Adjust the ND 1200R to the desired tilt position.
 Complete tightening the cap screw ( 5 ) to secure the ND 1200R.
Benchtop location and mounting
Rest the ND 1200R on a flat, stable surface, or bolt it to a stable
surface from the bottom using four 10/32 screws fastened in the
pattern shown at the right.
The dimensions are shown in millimeters.
Mounting stand assembly
Mounting hole pattern
5
4
3
2
1