HEIDENHAIN ND 1200R - Manual (Page 41)

ND 1200R Radial 41
1
.5 T
a
rg
et pat
ter
ns
Circle pattern
To create a Circle pattern:
 Press MENU>PATTERN>CIRCLE.
 Use the UP and DOWN ARROW keys to navigate between
parameter data fields and enter the parameter values required for
the pattern.
 Press the FINISH key. The targets in the pattern are added to the
Target list and the Current Position screen is shown.
 Press the FINISH key again to navigate to the first target in the
pattern.
Circle pattern screen
Circle pattern
Y
X
A
D
Parameter Description
Center X X axis coordinate for the center of the
pattern.
Center Y Y axis coordinate for the center of the
pattern.
Diameter Diameter of the circle for the pattern.
Num of Holes Number of holes in the pattern.
Angle of 1st Hole Angle applied to the first hole in the
pattern in relation to the X axis.
Drill Diameter Diameter of the drill bit.