Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 74)

ASPB Installation
74 ASPB Installation
Selecting a Board Location
Here’s how to use the tables to select a location for a board. Make a copy of
Table 16 to use as a template for recording information for board placement.
1. Identify which table of Table 17 through Table 19 to use based on your
product and serial number.
2. In Table 16 write the name of every board currently installed in your product.
Next, referring to the Board I/O Requirements table you are using, put a
check mark (
3 ) in each input and output block used by each board currently
installed in your Profile system. Start with the 1 block for each board.
3. Look in the Board I/O Requirements table you are using to determine what
are the input and output requirements of board you want to install.
4. Look in Table 16 for a slot with the required video router connections
available. Starting with the 1 block, put an
8 in each block that corresponds
to an input and output requirement for the newly added board. If the
recommended slot is occupied, or there are not enough input or output blocks
available, look at the alternative slots.
5. If all input and output requirements for the board match the available ones
for the slot, write the board name in the Board column for the slot and install
the board.
NOTE: If you can’t find an open slot with the I/O connections which meets
the I/O requirements of the board you want to install, you will have to move
existing boards. You can use the tables in this section to experiment with
various board locations before deciding on one.