beautypg.com

Removing the circuit board hold-down brackets – Grass Valley Profile Family Audio Signal Processing Board User Manual

Page 22

background image

ASPB Installation

22

ASPB Installation

Removing the Circuit Board Hold-down Brackets

There are two hold-down brackets located in the circuit board area of the chassis
that must be removed in order to install other boards.

To remove the board hold-down brackets:

1. Use the Torx tool with the T10 tip to remove the exterior screw

(

Êin Figure 2) that secures the rear board hold-down bracket.

2. Lift the bracket (

Ëin Figure 2) up and out of the chassis and set it aside.

3. Use the Torx tool with the T10 tip to remove the interior screw

(

Ìin Figure 2) that secures the front board hold-down bracket.

4. Lift the bracket (

Íin Figure 2) up and out of the chassis and set it aside.