Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 25)

Removing Analog Audio I/O Boards (PDR100 ONLY)
ASPB Installation 25
To remove adjacent tall circuit boards:
1. Remove all interior and rear panel cables from the circuit boards that are to
be removed.
2. Use the Torx tool with the T15 tip to remove the screw from the bracket
inside the chassis ( Ê in Figure 3) and the screw through the rear panel
outside the chassis ( Ë in Figure 3).
3. Extract the circuit board using the extraction lever on the front of the board
and the extraction ring at the back of the board to lift the circuit board free
of the connectors on the motherboard.
4. Replace the tall boards after all Analog Audio I/O boards have been
removed.
5. Proceed to “Installing the ASPB In Recommended Slot Locations” on
page 26.
Figure 3. Screw locations for board mounting bracket
9040-13
1
2