Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 29)

Connecting Audio Clock and Sharcnet Cables
ASPB Installation 29
Before You Start
Study Figure 4 and your unit to determine what video I/O boards are installed, and
then, do one of the following:
1. Follow a cabling example - Check to see if your configuration matches one
of those in Table 6 on page 31.
If so, turn to the correct page and use the cabling example as a guide to connect
the ASPB cables. When you are finished, proceed with “Reassembling the
Profile Chassis” on page 63.
If you don’t find your configuration in Table 6, go to step 2 which follows.
Although the actual board locations shown in the cabling examples may differ
from yours, the cabling rules are the same.
2. Follow the written instructions - If you do not find your configuration in
Table 6 use one of the following procedures:
- “Connecting Audio Clock Cables in the PDR 200/300” on page 46.
- “Connecting Audio Clock Cables in the PDR 100” on page 50.