Grass Valley Profile Family Audio Signal Processing Board - Manual (Page 53)

Connecting Audio Clock and Sharcnet Cables
ASPB Installation 53
2. To connect ASPB1 Sharcnet cables to the second Serial Digital I/O board:
a. Connect a Sharcnet ribbon cable between the ASPB1 Sharcnet Out2
connector and the Sharcnet In connector of the Serial Digital I/O board in
the next higher numbered board slot (
Ì in example Figure 16).
b. Connect a Sharcnet ribbon cable between the ASPB1 Sharcnet In2
connector and the Sharcnet Out connector of the Serial Digital I/O board
in the next higher numbered board slot (
Í in example Figure 16).
c. Go to step 3 if you have more SDI boards to connect, otherwise, do one
of the following:
- If you have two ASPBs installed go to “Connecting Sharcnet Cables
Between Two ASPBs” on page 57.
- If you have one ASPB installed go to “Reassembling the Profile Chassis”
on page 63.
Figure 16. Sharcnet cabling example for ASPB1 or ASPB
0047-15
ASPB1
J1 J17
Video Boards
Out 1
Out 2
In 2
In 1
In
Out
In
Out
ASPB2
1
2
3
4
Rear of Unit